Skip to content

Connection and Preparation

Important Reminders

  • ⚠️DO NOT launch PROSERVE right away.

Ensure that VR is fully set up and ready before proceeding.

Check the Router

  • Verify that the router is ready:
  • The LEDs on the front panel must be solid (not blinking) to indicate proper functionality.

Initialize the VR Headset

1. Put on the VR Headset

  • Wear the headset securely.

2. Verify Initial Startup

  • You should see the Vive logo appear on a black background

3. Calibrate the Environment

  • Slowly turn your head in all directions to allow the headset to calibrate.

  • Look at the ground, even if not visible to you in the headset, to assist with proper calibration

Note:

  • If you are in front of a table, it may interfere with calibration and result in an incorrect floor height.
  • Refer to the Troubleshooting section for guidance if this happens.

4. Confirm Initialization

  • After a few seconds:
  • The Vive logo will disappear.
  • You will see a void environment with:
    • A grid on the ground
    • A "Vive Streaming" message in front of you.
  • The trackers should appear in your view and move when manipulated.

Next Steps

Once these checks are complete and the environment is correctly calibrated, you can proceed to the final checks section before launching PROSERVE.